Suche

this reason, adhesive formulations with a proportion of monomeric MDI higher0.1% must be labelled with the GHS pictogram 08 (health hazard) according to the [...] The proportion of monomeric MDI contained in Jowat’s PUR MR adhesives is below 0.1%. According to the current EU regulation (EU1272/2008 and the associated amending

melt adhesives have a low content of monomeric diisocyanate (MDI) of less than 0.1 percent and are therefore not subject to hazard labeling. It is also important

presentano una percentuale di diisocianato monomerico (MDI) persino inferiore allo 0,1%, e sono pertanto da considerarsi non pericolosi. Un altro aspetto da considerare

ße 10 – 14, 32758 Detmold, Germany, can be contacted by phone at: +49 (0) 5231 749-0, e-mail: info @ jowat . de . B. Data Protection Officer: Jannik Wallbaum [...] legal duties of the data controller arising from section 6(2) of DGUV provision 1, section 8(2) of the German Act on Occupational Health and Safety (Arbeitssc [...] . The legitimate interest in this processing operation arises from Article 6(1) point (c) fo the GDPR in conjunction with the aforementioned legal provisions

hazard labeling requirement if the monomeric MDI concentration is less than 0.1 percent. Sustainable adhesive solutions Monomer-reduced—and therefore hazar

thus future-proof adhesive can be evaluated from various points of view (Figure 1): What is the raw material basis of the adhesive's formulation? What impact does [...] adhesives have a very low content of monomeric diisocyanate (MDI) of less than 0.1 % and therefore do not require hazard labeling. In addition, from August 24 [...] health are also relevant. The article is published in the magazine "adhesion 1/2023". You can download the original article down below.

hot melt adhesive: A very low monomer diisocyanate (MDI) content of less than 0.1 percent and therefore hazard-free labeling. In addition to increased occupational

pericolose (GHS), le formulazioni contenenti una percentuale di MDI monomero > 0,1% sono soggette a obbligo di etichettatura con il pittogramma GHS 08 (pericolo [...] degli adesivi MR, la percentuale di MDI monomero contenuta è inferiore allo 0,1%. In base all’attuale Regolamento UE (UE 1272/2008 e relativa modifica UE 790/2009) [...] initial strength. Low flame-spread characteristics according to IMO Resolution A.1/3.18 e. de en fr Jowatherm-Reaktant ® MR 608.90 Monomer-Reduced PUR Hot Melt

labeling requirements, due to its free monomer isocyanate content of less than 0.1 percent. An additional benefit is that employees will be able to process the

the textile industry. Due to a free monomer isocyanate content of less than 0.1 percent, the hot melt adhesive is not subject to hazard labeling and does therefore