Suche

powerful Jowacoll® adhesive is an all rounder in this sector and does not require the addition of a crosslinker. This property along with the broad range of [...] lamination Foil lamination of cut-out windows is another application that requires specific adhesives. The current products of the group of Jowacoll® dispersions [...] display and removal openings – Shelf-ready packaging with 180 ° flap bonding requires high tack. The new shelf-ready packaging for various end products, especially

eaktant® series. Convincing Benefits Standard use of aqueous dispersions requires a time-consuming interim storage period of up to 24 hours during the mattress [...] minimises storage periods and thereby increases cycle rates, it also only requires a significantly lower amount to achieve exceptional adhesive results in comparison [...] facilitate faster processes, however, they have to be dried out in a phase that requires a great deal of energy. This is where the reactive PUR hot melts are clearly

Jowat-Toptherm® 236.30. Adhesive formulations based on the new PO polymers only require low resin quantities for achieving the required tack. These adhesive formulations [...] this sector. In combination with the new Primer Jowat® 406.82 that does not require hazard labelling, it permits not only a shorter time for the profiles in storage

The efficient manufacture of filter systems requires modern adhesives that are tailored to fit the diverse manufacturing steps of lamination, pleating and frame

packaging. The primary packaging requires a strong adhesion and good cohesion at low counter pressure, while secondary packaging requires an adhesive with increased

hot melt adhesive is not subject to hazard labeling and does therefore not require compulsory training starting from 2023. On the performance side, the adhesive

optimum adhesion of adhesives on materials which are difficult to bond and require a surface treatment. These adhesion promoters are crucial for high bonding

when beverage cartons are closed in the section around the bottlenecks. This requires adhesives where the open time can be easily adjusted by variable temperature

cold. For years, the adhesive has therefore been used also for products that require a cooled supply chain to remain fresh until they reach their destination More

must be protected by an adequate surface coating. Moisture-resistant bonds require special reactive one- and two-component D4 dispersions. That latest generation [...] polymer isocyanate) adhesives have been tried and tested in applications that require durability class D4, in particular joints that are exposed to direct weathering